Press: ENTER again to finalize the setup. įirst, enter your PIN, then hold: * (until opener light blinks 3 times). Set a temporary code for others if desired. Enter: _ _ _ _ (new 4-digit code) Press and hold: ENTER (opener light should blink) If not, press again. On the keypad within 30 seconds, hold: * and # (until keypad stops blinking). You should reset the personal code and create a temporary code for service workers such as painters, carpet cleaners, cable technicians or any others you would like to provide access during this time. On Raynor keypads, the basic programming steps are explained on the underside of the cover. The garage door opener should have activated upon the second press of the HomeLink button. Return to the vehicle and firmly press the programmed HomeLink button in the vehicle TWO times (press and hold each time for two seconds). (Note: you only have 30 seconds in which to initiate step 5.)Į. Press the Learn Button on the Raynor opener for one second and release. Release both buttons only when the indicator light changes from a slow to a rapid blink.ĭ. Simultaneously press and hold both the hand-held transmitter button and the designated HomeLink button in the vehicle. Hold the end of the hand-held remote control (transmitter) you wish to train approximately 1-3 inches from the HomeLink surface-keeping the indicator light in view.Ĭ.
Some vehicles may require the ignition to be in the “ON” position during the entire programming process.ī. Press and hold the two outside HomeLink buttons on the remote - releasing only when the indicator light begins to flash rapidly (after 20 seconds). Note: The steps below apply to vehicles equipped with the HomeLink® rolling code system (the most common system in 1997 vehicle models and newer).Ī.
Finally, reinstall the visor clip on your remote. Test the programmed button on your remote. The garage door opener lights will flash or two clicks will be heard.į. Press and hold the button on your remote while the indicator light on the opener is glowing. The opener’s Learn button indicator light will glow for 30 seconds, the time you have to reprogram the remote control.Į. Press and release the “Learn” button on the opener. Press any other button to exit this programming step.ĭ. Press that button a number of times that corresponds to the type of garage door opener you have.ģ15 MHz Security+ ® (Purple Learn Button)ģ90 MHz Security+ ® (Red/Orange Learn Button)ģ90 MHz Billion Code (Green Learn Button)Ĭ. Choose an open/close button to use for your garage door. On the Raynor remote model G893RGX, that button is located under the visor clip.ī. Press the remote control program button until the LED light turns on. Setting up a new remote control or resetting an existing one are done the same way:Ī. Following are common steps using Raynor’s 3-button control as the example. Remote controls vary in button configuration and programming details. That remote, once reset, will then be used to pair the opener with your vehicles. Note: Before you can pair the opener with your vehicles, you’ll need a working hand-held remote control that is programmed to the new settings on your opener. To clear old codes, press and hold the button at least 6 seconds.ĬAUTION: Stay clear of the door as it will open and close when you activate new control devices.Ģ. You’ll need a ladder or step stool to reach the Learn button.
Depending upon opener model, it may have a color LED light next to it. It is located on the back of the motor housing, facing away from the garage door. To delete all previous programming, locate the Learn button on the opener.
0 kommentar(er)
